Get Your Quote for Commercial Glass Doors
Complete the form below to enquire about Windows & Doors Winnipeg and its Commercial Glass Doors anywhere in Weston Shops, Winnipeg.
Call Windows & Doors Winnipeg on (431) 444-8111 about Commercial Glass Doors in Weston Shops, Winnipeg and get the fittings specified right.
Complete the form below to enquire about Windows & Doors Winnipeg and its Commercial Glass Doors anywhere in Weston Shops, Winnipeg.
We've seen every issue a busy storefront entry can develop. Here are the problems our clients call us about most often.
A door that hangs open or needs a shove to latch usually points to a worn closer or a frame that has shifted out of square. Left alone, the gap lets in drafts and makes the entry look neglected to every customer walking in. We adjust or replace the closer and realign the frame so it latches securely.
Impact from carts, deliveries, or accidental contact can crack or chip commercial glass even when it is properly tempered. A damaged panel is a liability risk and undermines the storefront's first impression. We replace the affected panel with code-compliant glass matched to the existing frame.
A door that slams shut usually has a closer that has lost its hydraulic resistance or was never adjusted correctly for the door's weight. Repeated slamming stresses the hinges and glass edge over time. We install or recalibrate heavy-duty closers rated for commercial cycle counts.
Patch fittings on a frameless door carry the full hinge and closer load directly into the glass edge, so loosening hardware shows up faster than on a framed system. Ignoring it risks stress cracks at the fitting points. We inspect and retighten or replace patch hardware before it compromises the glass.
A missing or incorrect exit device is one of the most common reasons a commercial entry fails a code inspection. Operating without compliant panic hardware creates real liability exposure. We assess occupancy requirements and install hardware that meets code the first time.
Automatic entries that fail to open or stay stuck usually have a sensor misalignment or a motor component reaching the end of its service life. A malfunctioning automatic door can trap customers or block accessible entry entirely. We diagnose the sensor and motor system and repair or replace the failed part.
Persistent fogging between panes in an insulated glass unit means the seal has failed and moisture has gotten inside. This cannot be cleaned away and only gets worse over time. We replace the sealed glass unit rather than the whole door frame when the frame is still sound.
Debris, grit, or worn rollers in the threshold track cause a sliding door to stick or require extra force to open. Continued forcing accelerates wear on the rollers and track alike. We clear and service the track system and replace rollers that have worn past a safe tolerance.
A rebrand or renovation often leaves an old aluminum door frame looking mismatched against new signage and finishes. An inconsistent storefront undercuts the investment made in the rest of the update. We install new framing and glass finished to match the updated brand look.
We wanted a fully frameless glass entry for our new showroom and Prime Windows Toronto walked us through the patch hardware options clearly. The install took about two weeks from measurement to finished door because the glass had to be cut to spec, but the wait was worth it.
Our old aluminum door was dragging on the threshold and barely closing. The technician from Prime Windows Toronto had a new framed door installed and adjusted within a single afternoon. Customers noticed the difference immediately.
The door itself installed smoothly and closed perfectly on the first try. The specific exit device we needed for code compliance had a longer lead time than expected, which pushed our final walkthrough back about a week, but the team explained why upfront.
I had no idea there was this much to consider between framed and frameless doors. The team broke down maintenance, cost, and how each would hold up with our foot traffic before we picked anything. Genuinely appreciated the honesty.
Our old closer was letting the door slam every time someone left in a hurry. New heavy-duty closer and continuous hinges completely solved it. The whole visit took under two hours.
Prime Windows Toronto recommended automatic sliding for our clinic entrance instead of a standard swing door once they saw our patient traffic. It has made a real difference for anyone coming in with a stroller or mobility aid.
Most jobs move through all four in a single visit.

Phone for anything urgent, or use the form for planned work. Both get a same-day response.
Frames, hinges, thresholds, seals, and locks are all checked as one system rather than separately.
A firm price up front, then the work carried out with the stock already on board.
Our guarantee runs well past the point where a poor repair would have shown itself.
Door, window, and glass work from Windows & Doors Winnipeg across Weston Shops, Winnipeg, from a single hinge to a full elevation of replacement units.
For anything urgent, calling is fastest. For everything else, the form gets a reply the same working day.
CALL NOW (431) 444-8111 EMAIL US Click to compose a messageKept confidential, always.